Home | | About Us | | Contact Us | | Quality policy

 

  RUBBERIZED CORK GASKETS AND FRAME

In our ongoing efforts to reduce component cost, time and labor in industries, we have come up with a unique idea to manufacturer Rubberized Cork Frames / Gaskets and Components. We manufacture Cork frames of any shape and type; it may be Rectangle, Square, Round, ‘ L ` type or any oblong shape. Cork frames manufactured by us are completely leak proof as the same are made JOINT LESS contrary to the one, which are usually being offered with minimum two to four joints.

  We are at present supplying these Frames or ready to use Gaskets to our Customers strictly as per their required Standards. We are also manufacturing complete set of Cork Gasket for Transformer Industries, which can include as many as 52 Gasket of different Shape and Size.
 

Tips for correct tightening sequence.

It's good practice to tighten a number of bolts from the middle towards the outside of a group in three steps. Initially just until you feel some resistance, then about half the final torque, and finally to the correct torque value.

 

SR
.NO		 Mechanical
Properties.		 GR/GCS - R & B
(Moderate oil Resistant)		 GR/GCS - S & P
(Good oil Resistant)		 GR/GCS - I & II
(Very good oil Resistant)
RC-50      RC-70        RC-80 RC-50B     RC-70B     RC-80B RC-50C    RC-70C     RC-80C
1 Hardness IRDH 50-10   70±10   80±10 50±10     70±10     80±10 50±10   70±10   80±10
2 Dimensional charge percent Max. 1 5   1.5    1.5 1. 5     1.5     1.5 1. 5   1.5    1.5
3 Tensile Strength
Kg/cm2 (KPa*) Min.		 6.63    9.18    12.75
(650)    (900)    (1250)		 1 7.14    12.75     15.50
(700)    (1250)   (1550)		 12.75   15.50   19.50
(1250)   (1550)  (1900)
4 Compressibility at
28 Kg/cm2 (2800 KPa) 		45-60   35-50   25-35 45-60   35-50    25-35 35-45     25-35    15-25
5 Tpencem45-60  Recovery Percent Min. 80     80     80 80    80     80 80    80     80
6 Compression Set Percent Max. 80     85     90 80     85     90 80 85 90
7 Chemical Test on water extracts
a) PH. where applicable
b) Chloride content(as chloride ion)
c) Sulphate content(as sulphate ion)		 5.0 to 8.50
0.2 percent Max
0.2 percent Max		 5.0 to 8.50
0.2 percent Max
0.2 percent Max		 5.0 to 8.50
0.2 percent Max
0.2 percent Max
8 Volume change after immersion
in ASTM oil No 3 for 70 hours		 40 percent Max 25 percent Max 15 percent Max

 
Products | | About Cork | | Get A Quote| | E-mail


       Site Created and Hosted By : Softweb Technology